Nautilus Trimline T523 Owner's Manual page 28

PROBLEM
Treadmill will not start
Elevation not accurate
Speed not accurate.
Walking belt slips
Walking belt not centered.
Heart rate not displayed
(using chest strap)
Treadmill squeaks
LOCATING THE CIRCUIT BREAKER ON YOUR TREADMILL
near the front of the treadmill, near the power cord
power cord
T T R R O O U U B B L L E E S S
T T R R O O U U B B L L E E S S
1. Not plugged in.
2. Safety pull pin not inserted.
3. Treadmill circuit breaker tripped.
1. Out of calibration.
1. Out of calibration.
2. Set in wrong units (kilometers or
miles)
1. Walking belt loose.
1. Walking belt tension not
centered across the rear roller.
1. Transmitter not making good
contact with skin.
2. Electromagnetic interference.
1. Pivot points need lubrication.
possible circuit breaker
locations
H H O O O O T T I I N N G G
H H O O O O T T I I N N G G
CAUSE
Not tripped
28
G G U U I I D D E E
G G U U I I D D E E
CORRECTION
1. Plug into three prong grounded
outlet.
2. Insert safety pull pin.
3. Reset circuit breaker
1. Recalibrate unit (See
Calibration Instructions).
1. Recalibrate unit (See Calibration
Instructions)
2. Change units (See Calibration
Instructions)
1. Adjust walking belt tension
(See "Taking Care of Your
Treadmill")
1. Adjust walking belt tension
(See "Taking Care of Your
Treadmill")
1. Moisten skin contact area on the
chest strap, or turn chest strap
upside down.
2. Turn off any television,
microwave, or computer within
6 feet (2 meters) of treadmill
1. Lubricate pivot points.
(See Exploded View)
Tripped