Appendix A-Required Tools - Nautilus StairMaster ClubTrack 2100 Series Service Manual

Required Tools
This is a list of the most common tools you will need to service the treadmill.
Table 6–1. Required Tools and Uses
Tool
Socket wrench
13-mm socket
10-mm socket
9/16" socket
9/16" open-end box wrench
3/4" wrench
15/16" open-end box wrench
5-mm Allen wrench
M-4 Allen wrench
M-4 Allen wrench
T-10 Torx screwdriver
T-15 Torx screwdriver
#1 Philips screwdriver
Tape Measure
Pliers
Diagonal cutters
Multimeter
Vacuum
#000 Steel Wool or Scotch-Brite ™
pad
®
ClubTrack 2100 Series Treadmill Service Manual
Purposes
General
Removing and installing tracking bolts, front roller retainers, motor
hardware, and grade block hardware
Removing and installing deck screws, VSD mounts, configuration
mounts, and grounding screws
Removing and installing upper grade actuator mount; adjusting motor
drive belt tension
Removing and installing upper grade actuator mount
Adjusting feet
Adjusting motor drive belt tension
Removing and installing console and uprights
Removing and installing hood screws
Front cosmetic cover
Ergo PCB
Removing and installing three (3) screws underneath the console
Removing and installing Ergo and CHR housings
Adjusting belt tension
General
General
Electrical troubleshooting
Cleaning the motor housing and side rails
Cleaning the wax from front and rear rollers
Appendix A
72