Nokia 7368 ISAM ONT E-240W-A Product Manual page 60

Intelligent services access manager

Table of Contents

Replace an E-240W-A indoor ONT

Release 06.00.00h | January 2019 | Edition 08

Disconnect the fiber optic cables.

Danger — Fiber cables transmit invisible laser light. To avoid eye

damage or blindness, never look directly into fibers, connectors, or

adapters.

Unplug the fiber optic cable with SC/APC connector (or SC/UPC for the 3FE46964DA

variant) from the ONT; see Figure

Attach a fiber dust cover to the end of the SC/APC or SC/UPC connector.

Replace the ONT with a new unit:

On a flat surface, such as a desk, substitute the new ONT for the old ONT on a flat

surface, horizontally resting on its four feet.

On a wall.

Remove the old ONT from the wall.

Attach the wall mount adapter bracket (shipped with the ONT) to the two wall

mounting key holes on the new ONT.

iii

Attach the new ONT to the wall.

Connect the Ethernet cables directly to the RJ-45 ports; see Figure

RJ-45 ports.

Connect the POTS cables directly to the RJ-11 ports as per local practices; see Figure

the location of the RJ-11 ports.

The RJ-11 port to the left is labeled 1 for Line 1 while the port on the right is labeled 2 for Line

If required, have approved service personnel who are trained to work with optic fiber clean

the fiber optic connection. See the 7368 ISAM ONT Configuration, Management, and

Troubleshooting Guide for more information about fiber optic handling, inspection, and

cleaning.

Danger — Fiber optic cables transmit invisible laser light. To avoid eye

damage or blindness, never look directly into fibers, connectors, or

adapters.

3FE-46974-AAAA-TCZZA

7368 ISAM ONT E-240W-A Product Guide

for the location of the fiber optic port.

for the location of the

for

Issue: 01

Table of Contents

Show Quick Links

Table of Contents