Dakota Digital VFD3 Installation And Operation Manual page 19

WATER TEMP SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When
"WATER" is displayed, press the switch again and then release it. The message display should
switch between "UNIT", "WARN" and "TEST".
METRIC SELECTION
If you are setting the system up for metric displays, press the switch when "UNIT" is
displayed.
Press and release the switch until "KPH C" is displayed.
Press and hold the switch unit "DONE" is displayed.
Temp warning setup
When "WARN" is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
OIL PRESSURE SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When "OIL" is
displayed, press the switch again and then release it. The message display should switch
between "WARN" and "TEST".
Pressure warning setup
When "WARN" is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
DIM PRESET SETUP
Press and hold SW 1 switch while turning the key on. Release the switch. When "DIM"
is displayed, press the switch again and then release it. 88 or 888 will be displayed on the fuel,
oil, volt, and water displays. The system will dim down to the current preset level.
Press and hold SW 1 until the desired night brightness is shown. When the system
reaches its lowest brightness it will start over again at full brightness.
Once the night brightness is correct, press SW 2 to save it.
17
650066