Tachometer Setup - Dakota Digital VFD3 Installation And Operation Manual

TACHOMETER SETUP

The control box can be set to read from 1-15 cylinder ignition signals. It can also be set
to read either 12 volt tach signals or 5 volt tach signals found on some engine computers. The
digital tachometer update rate can be adjusted between slow, mid, and fast. The rpm
warning/shift point can be adjusted from 2200 – 14800. The tachometer will read from 350 –
17,500 rpm. At rpm's above 9990 the reading will be displayed as rpmx1000 (12,000=12.00).
Press and hold SW 1 switch while turning the key on. Release the switch. When "TACH"
is displayed, press the switch again and then release it. The message display should switch
between "ENGINE", "UPDATE", "WARN" and "SIGNAL".
Engine cylinder setup
When "ENGINE" is displayed press and release the switch.
The current cylinder setting will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
Display update setup
When "UPDATE" is displayed press and release the switch.
The update setting will be displayed. (1=slow, 2=mid, 3=fast)
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
Rpm warning setup
When "WARN" is displayed press and release the switch.
The current warning point will be displayed.
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
Tach signal setup
When "SIGNAL" is displayed press and release the switch.
The setting will be displayed. (NORMAL or LO VOLT)
Press and release the switch until the desired setting is displayed.
Press and hold the switch until "DONE" is displayed.
16
650066