Dakota Digital VFD3 Installation And Operation Manual page 14

GAUGE SYSTEM FEATURES
Mileage readings
• Million mile odometer
• Re-settable trip mileage (0-999.9)
• Re-settable service mileage (0-9999)
Performance readings
• High speed recall. This is reset at power up and can be manually reset.
• High rpm recall. This is reset at power up and can be manually reset.
• 0-60 mph (0-100kmh) time. This is reset automatically when speed is zero.
• ¼ mile time. This is reset automatically when speed is zero.
• ¼ mile end speed. This is reset when the ¼ mile time restarts.
Hour meter
• Re-settable hours (0-999.9)
English/metric conversion
• Alternate speed can be displayed on message display.
Special tachometer displays
• On systems that do not have bar graph displays, a bar tach can be shown on the
message display.
• On systems that do not have a digital tachometer display, the rpm can be shown on the
message display or the tachometer reading can be switched onto the speed display.
Demonstration mode
• Holding switch 2 while turning on the key will start the system going through a preset
sequence of readings. To exit the demo mode, turn the key off. You may also wire up a
separate switch to power the gauges for demo mode without powering the entire vehicle.
Built-in Indicators
• Left/Right Turn signal indicators
• High Beam indicator
• Check Engine indicator
• Brake warning indicator
• 4x4 indicator
• Wait to Start indicator
• Cruise control indicator
• Gear position indicator which displays full gear word
Special outputs
• Shift output to turn on external light
• Selectable 2000 ppm or 4000ppm speed output for cruise or ECM
12
650066