Message Displays - Dakota Digital VFD3 Installation And Operation Manual

SW 1 or Speed switch
The SW 1 terminal is used for selecting the various speed, distance, and performance
displays and also for entering the setup menu. The SW 1 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 1 and the other terminal to a ground. When the button is
pressed and released, the speed message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the speed is dedicated to speed/performance messages.
On systems with one message display the speed/performance and rpm/warn messages will use
the same display.
SW 2 or Tach switch
The SW 2 terminal is used for selecting the various rpm, engine, and warning displays
and also for entering the demonstration mode. The SW 2 input is activated by a ground
connection. The push button switch supplied (or any normally open switch) is wired by
connecting one terminal to SW 2 and the other terminal to a ground. When the button is
pressed and released, the tach message display will change. When the button is pressed and
held for a few seconds, any re-settable information displayed will be zeroed. On systems with
two message displays the one below the tach is dedicated to rpm/warn messages. On systems
with one message display the speed/performance and rpm/warn messages will use the same
display.
To enter DEMO mode, press and hold the switch while turning the key on.

MESSAGE DISPLAYS

On systems with two message displays, switch 1 will toggle between the speed message
displays and switch 2 will toggle between the tach message displays.
On systems with one message displays, switch 1 will either switch from the tach
message to the speed message or toggle to the next speed message. Switch 2 will either
switch from the speed message to the tach message or toggle to the next tach message.
Speed message displays
ODOMTR
TRIP
SERVIC
0-60 T
HI SPD
QUARTR
QT MPH
KPH xxx
Tach Message displays
HI RPM
RPM-WN
ENGINE
BRAKE
4 WD
WAIT
GEAR
HOURS
BAR (on systems with no bar graph)
RPM (on systems with no digital tach)
TACH (on systems with no digital tach) digital tach readout on speed display
DESCRIPTION
odometer mileage (0-999,999)
trip odometer mileage (0-999.9)
miles since last service (0-9,999)
0-60 mph time in seconds (0-25.5)
high speed recall (0-255)
¼ mile time in seconds (0-25.5)
end of ¼ mile speed (0-255)
kph conversion (or mph conversion if metric)
DESCRIPTION
high rpm recall (0-18,000)
rpm warning point (displays "SHIFT" when exceeded)
check engine indicator
brake warning indicator
4 wheel drive indication
diesel wait to start indicator
gear shift position indicator
hours system has been on with tach signal (0-999.9)
bar tach readout on message display (0-8)
digital tach readout on message display
10
.
.
650066