Advertisement
Installing the Switch and the
Wiring Harness
1. Remove and discard the hole plug that is installed in
the hole near the hour meter in the side of the seat pan.
1. Light switch
2. Insert the switch into the hole (Figure 3).
3. Connect the appropriate connector of the light kit
wiring harness to the back of the switch (Figure 4).
1
2
1. Light kit wiring harness
4. Connect the appropriate connector of the light
kit wiring harness to the unused connector of the
hour-meter wiring harness (Figure 5).
1
1. Hour-meter wiring harness 2. Light kit wiring harness
5. Route the light kit wiring harness as shown in Figure 6.
Figure 3
2. Hole plug
G025240
Figure 4
2. Switch
2
Figure 5
1
2
G025239
1. Light kit wiring harness
6. Connect the remaining connectors to the lights.
7. Secure the wiring harness with the cable ties in the
locations shown in Figure 6.
8. Ensure that all of the components are secure.
9. In a well-ventilated area, start the machine and set the
engine to full speed.
10. Operate the switch, and ensure that both of the lights
work.
Important: If the lights do not turn on, check all
the connections.
11. If necessary, loosen the screw and the nut on the sides
of each light, and rotate the lights up or down and from
side to side to attain the desired operating position.
Important: Secure the adjustments by tightening
the screw and the nut on the sides of each light.
G025241
3
1
Figure 6
Underside shown
2. Cable ties
G025245
Advertisement
