Advertisement
Installing the LED Lights
1. Align the left light mounting bracket with the hole in
the rear left corner of the seat pan (Figure 1).
Note: The bracket should be nearly parallel with the
ground. If it is not, try the other bracket; refer to
Figure 2.
7
6
5
4
1. LED light
2. Light mounting bracket
3. Nut (included with light)
4. Locknut (M6)
Figure 1
5. Washer (M6 x 12 mm)
6. Washer (1/4 x 7/8 inch)
7. Hex-head bolt(M6 x 20
mm)
1
2
3
2. Secure the bracket to the seat pan with a hex-head bolt
(M6 x 20 mm), a large washer (1/4 x 7/8 inch), a small
washer (M6 x 12 mm), and a locknut (M6).
3. Align the bottom of the LED light on the left side with
G025237
the hole on the light mounting bracket (Figure 1).
4. Secure a light to the mounting bracket by tightening the
locknut (included with the light) as shown in Figure 1.
5. Repeat steps 1 through 4 to install the right light.
2
Figure 2
G025238
Advertisement
