modway EEI-2279 Quick Start Manual

Swing chair

EEI-2279

SWING CHAIR

Thank you for purchasing the MODWAY SWING CHAIR！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 15 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that has been provided.

6.Please keep all fitting out of reach of children.

Chair Base

Customer Service 908-368-1025︱www.modwayfurniture.com

Stand

and then follow the simple step-by-step

Basket Frame

Bolt M10x60mm

Nut M10

Spring

Spring Holder

Allen Wrench

Open Wrench

Cushion

Page 1 of 2

Table of Contents

Need help?

Do you have a question about the EEI-2279 and is the answer not in the manual?

Page 1 EEI-2279 SWING CHAIR Thank you for purchasing the MODWAY SWING CHAIR！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step and then follow the simple step-by-step instructions.
Page 2 EEI-2279 SWING CHAIR STEP 1: Please put all chair parts on a carpeted or padded area. Find the hardware package inside of the tube on Chair Base (1). Insert Stand (2) into Chair Base (1) as shown. Secure by using 2 pieces of Bolt (A) with 2 pieces of Nut (B). Note: Bolt (A) should be inserted by the left side.