Attaching The Grass Collection Box; Operation; Adjusting The Cutting Height - Ryobi LM-1320 Owner's Operating Manual

ATTACHING THE GRASS COLLECTION BOX

1. Ensure that the grass collection box has been
assembled correctly.
2. Lift the rear deflector (8) on the mower deck.
3. Pass the collection box under the handlebar,
align the attachment hooks and place the
collection box into position.
4. Lower the rear deflector, so that it now rests on
the grass collector box.

ADJUSTING THE CUTTING HEIGHT

NOTE: Stop, release switch lever and wait until the motor stops before adjusting height. The blades
continue to rotate for a few seconds after the machine is switched off, a rotating blade can
cause injury.
For the first cut of the season, a high cutting adjustment should be selected.
The cutting height can be selected among 20mm, 40mm, or 60mm by adjusting the front and rear wheels.
Front wheel adjustment (Fig.6)
Pull the front wheel axle on either side of the mower deck in turn and relocate it in the required position.
Rear wheel adjustment (Fig.7)
Pull the rear wheel axle along the slot and lift the wheel, then relocate it in the required position.
Note:
1. Set the axle in the upper position for the lowest cutting height, the middle position for the medium height,
and lowest position for the highest cut.
2. All wheels must be at the same position.
3. The lowest cutting height is only suitable for trimming a very level, short lawn. High and medium positions
are recommended for normal use. Never use the mower with the wheels set in different positions.
ASSEMBLY
(Fig. 5)

OPERATION

Fig. 6
7
8
2
Fig. 5
Fig. 7