How To Use The Appliance - OBH Nordica Cosy HUG Instruction Manual

Heating plaid
Table of Contents

Advertisement

Available languages
  • EN

Available languages

28.
For additional protection, we recommend
installation of a residual current device (RCD) with
a rated residual operating current not exceeding
30 mA. Ask your installer for advice.
29. The appliance is only for private use and should
not be used professionally or medically, as the
appliance is not covered by the EU directive of
electro-medical products.
30.
If the appliance is used for other purposes than
intended, or is it not handled in accordance with
the instruction manual, the full responsibility for
any consequences will rest with the user. Any
damage of the product is not covered by the
warranty.
This product comprises a safety system that will cut off the power supply
within milliseconds in case of a short circuit or an abnormally high power
consumption. In such case, it is not possible, for safety reasons, to use the
heat blanket. Consequently, the heat blanket should be discarded, see more in
section "Disposal of the appliance".

How to use the appliance

Plug the appliance to a wall outlet, the display shows "8" for a few seconds
and afterwards just one point will be displayed. Sit or lie down comfortably with
the heat blanket as you want it and keep the switch within reach. Make sure
that the cord between the heat blanket and the on/off button is not folded or
coiled.
Switch on the heat blanket by pressing the on/off button. The heat blanket
starts automatically at temperature setting 4 and the timer setting at 30
minutes.
You can now set the temperature by means of the temperature buttons + and
- (the button closest to the display) from 1-10, where 10 is displayed as "H" (1
= lowest temperature, H = highest temperature) depending on how warm you
want the blanket to be. Now press the timer button (the button in the middle)
+ and - if you want to set the time to be off between 10 and 90 minutes with
intervals of 10 minutes. The display shows 1 for 10 minutes, 2 for 20 minutes
etc. up to 9 for 90 minutes. The chosen setting flashes for a few seconds and
will then be on constantly.
30
4096_CS_UVN_1014.indd 30
2014-10-17 10:42:48

Advertisement

Table of Contents
loading

Table of Contents