Disposal Of The Appliance - OBH Nordica SHARPX 9960 Instruction Manual

Collect the knife/knives to be sharpened.
Press down the switch-button with left-hand thumb and hold the knife in our
right hand. NB! Keep your fingers away from the knife to avoid injury!
Place the blade (where the blade begins, by the handle) in the wheel with a
slight pressure and pull it slowly, during approx. 3-4 seconds, towards you.
Check the sharpening result after 3 to 5 times. Repeat until desired sharpening
is achieved. Release the switch-button.
For best result:
It's important to position the knife straight in the track during sharpening and
do NOT PRESS the knife down. Pull it through the wheel with a slight pressure.
If you press too hard the blade of the knife will run against the black edge
of the wheel and this may cause marks on the blade. This applies especially
knives with frosted/matt blades.
Wipe off the knife-blade after the sharpening is finished.
Never stick your fingers into the rotating wheel.
The sharpening-wheel works on both stainless steel and carbon steel.
Do not use with serrated knives.
Cleaning
Wipe off the outer housing with a damp cloth and dry.
The sharpening-wheel can be cleaned with a small brush (for ex. a toothbrush)
that is held towards the wheel while rotating.
If you wish to remove eventual grinding dust that is collected inside the knife
sharpener, unscrew the lid positioned underneath the appliance and shake
out and/or use a vacuum cleaner to suck out eventual dust from the opening.
Always unplug from the mains supply before the lid is being removed!
Put back the lid and tighten the screws.

Disposal of the appliance

Legislation requires that all electrical and electronic equipment must be
collected for reuse and recycling. Electrical and electronic equipment
marked with the symbol indicating separate collection of such
equipment must be returned to a municipal waste collection point.
25