Installation; Operation - Gima 31001 Use And Maintenance Book

If you move the microscope from a cold to a warm environment, or vice versa, let the instrument
acclimate for about half an hour before using it to avoid the formation of condensate.
Do not use the equipment in case it is damaged. Apply to your retailer.
Avoid precarious repairs. Repairs shall be carried out with original spare parts only, which
shall be installed according to the intended use.
Since the product is made of corrosion-proof materials suitable for the enviromental conditions foreseen
for its normal use, does not require special care, however it is necessary to store it in a closed place
making sure that is protected from dust and dirt to assure its hygenic conditions. Moreover, it is
recommended to store the product in a place which can be reached easily by the personnel in case of
necessity.
Always remember that packing elements (paper, cellophane, stitches, adhesive tape, etc.)
can cut and/or hurt if they are not carefully handled.
They shall be removed with adequate means and shall not be left at the mercy of irresponsible
persons; the same is valid for tools used to remove packages (scissors, knives, etc.).
After opening the packages, first of all it is necessary to check all pieces and parts composing the
product. Check that they are all present and in perfect conditions.
After removing the microscope from its box, position the binocular on the microscope:
- Remove the screw on the right side of the upper part of the stand where the binocular housing is
positioned using the supplied setscrew wrench.
- put the lower part of the binocular in the housing on the upper part of the stand.
- screw the fastening screw back on.
- Screw three lenses
- Insert the eyepieces
Disassemble the binocular, the lenses and the eyepieces every time you need to put away the product.
The eyepieces are not fixed into their slots in the binocular. Remove the eyepieces before
tilting or turning over the microscope.
OBSERVATION
1. Plug the power cable in the outlet on the back of the microscope and connect it to the power outlet.
Set the main switch on the back of the microscope to "I" to switch on the device;
2. Put one of the lenses in operating position by rotating the lens holder wheel
specimen that is on the stage;
3. Adjust the inter-pupillary distance and the diopter of the binocular;
4. Adjust the height of the condenser, the brightness and the aperture of the diaphragm until there is
enough light. When lenses 4X or 10X are used, lower the property of the condenser to obtain a
symmetrical lighting;
5.
To change the lenses, rotate the lens holder wheel and slightly focus with the fine adjustment knob
04 . When using lens 100X, put a drop of cedar oil between the lens and the specimen.
PRESCRIPTIONS
01
onto the lens holder wheel
02 into the specific slots on the binocular.
UNPACKING

INSTALLATION

03
.

OPERATION

11
03 , then focus the