Trotec BH30 Operating Manual page 8

Setting the mode
Info
If the desired humidity value is lower than the humidity
level of the room, please use Dehumidifier mode. If
the desired humidity value is higher than the humidity
level of the room, please use Humidifier mode.
ü The device is switched on.
ü The SET indication (9) appears on the display.
8
Reset
socket hygrostat BH30
1. Press the Power button (13).
ð The device now enters standby mode.
ð The currently active mode is indicated at the top of the
display.
2. Press and hold the Arrow up button (14).
3. Press and hold the Power button (13) for 2 s.
ð The respectively other mode is set.
Resetting the device to the factory settings
You can reset the device to its factory settings. The saved target
values for the Humidifier and Dehumidifier modes will be set
back to 40 % RH.
1. Use a suitable tool (e. g. the end of a straightened
paperclip or the tip of a pencil) to press the Reset
button (12) for approx. 2 s.
Switching the device off
1. Press the Power button (13).
ð The operation indicator LED (6) goes out.
ð The device is switched off.
2. Remove the mains plug of the terminal device from the
plug adapter by holding the device with one hand and
pulling the plug with the other.
3. Unplug the device from the mains socket.
Reset
EN