Operation - Trotec BH30 Operating Manual

Socket hygrostat
Hide thumbs Also See for BH30:
Table of Contents

Advertisement

Operation

Removing the battery insulation tab
Note
Make sure that the surface of the device is dry and the
device is switched off.
The battery is already inserted. The battery tab must be
removed before initial start-up to close the contact between
battery and device. To do so, please proceed as follows:
1. Pull the plastic strip out of the battery compartment.
ð The device is ready for operation.
6
Attaching the warning sign
Prior to initial start-up, check whether the warning sign at the
rear of the device is in your local language, if not, paste the
proper one over it. A warning sign in your native language is
supplied along with the device. Please proceed as follows to
attach the warning sign to the rear of the device:
1. Remove the label in your local language from the supplied
film.
2. Affix the label in the intended position at the rear of the
device.
Switching the device on
1. Plug the device into a properly fused socket.
2. Plug the power cable of the terminal device (consumer)
into the plug adapter.
3. Press the Power button (13).
ð The operation indicator LED (6) is illuminated in red.
ð The device is switched on.
socket hygrostat BH30
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BH30 and is the answer not in the manual?

Table of Contents