Initial Setup - Fire Cam Mini 1080 User Manual

① LED ② Power / Shutter
⑤ USB ⑥ Micro SD Card
Initial Set Up
1. Unscrew the rear cap located at the back of the
Fire Cam MINI 1080. Install a micro SD memory card, minimum
speed Class10/U1, maximum 128gb, into the rear slot. To insert the
micro SD card, slide the micro SD card into the card slot on the back
of the Fire Cam MINI 1080 with the card label facing down. The micro
SD card will click into place once it is inserted past flush with the
camera.
2. Insert battery until plastic clip catches and secures battery in
camera. Plastic Clip must remain on battery to secure it in camera.
Use tab of clip to remove battery when needed.
3. To charge battery, plug the USB charger to the camera. The blue
light is on while charging and goes off when the battery is fully
charged. You can record up to 60 minutes with one charge.
*NOTE RECHARGEABLE BATTERIES WILL LAST BETWEEN 1-2
YEARS. ALSO THE BATTERIES WILL NEED TO BE RECHARGED
WITHIN 2 WEEKS OF NO USE.
③ Rear ④ Mode
Cap Switch
⑦ Battery ⑧
Microphone