Installation - Bandai Namco JUMBO JUMPIN' Operator's Manual

Jumpin' Jackpot

INSTALLATION

Note: Shipping damage may void the warranty. In case of shipping damage, contact your
distributor and the transportation carrier immediately.
1. Unpack the game.
2. Position the game close to its final location.
3. Carefully raise the main game back panel to a vertical position and attach the left
and right side supports using the supplied 16-bolts and 4 mounting brackets. See
Figure 1.
4. Place the floor mat into position and attach it to the lower back panel frame using
the supplied 2 bolts. See Figure 1.
5. Connect the floor mat cable to the mating cable located at the bottom center of the
light ring.
6. If a single stand alone game is being installed, skip to step 7. If two games are to be
linked together: Remove all but the top two screws on the back panels. Loosen the
top two screws on both games a couple of turns. Then feed one supplied linking
cable (Cat 5 RJ45 patch cord) through the back panel holes and attach one end to
each main logic port labeled "LINK". See Figure 2. Once connected, reinstall all back
panel screws being careful not to over tighten.
7. Attach the power cord to the game and wall outlet, and turn on the power. Wait a
couple of minutes while the game completes its power on diagnostics. If this is the
first time the game is turned on, you may be presented with a screen reporting
"MASTER UNIT NOT DETECTED". This is normal operation. and you should press
the "MENU" button to enter the game options mode. If two games are linked, only
press the menu button on one of the games (it doesn't matter which game you
choose)
8. Follow the on screen prompts. Review and change any of the options as required. If
necessary, refer to the Option Menu section of this manual for detailed explanations
for each option. When complete, exit the options mode by pressing the menu
button.
The game is ready to play!
3
Operators Manual