Pump Supply - PIAGGIO Beverly 125 Service Station Manual

Beverly 125
at a current equal to 1/10 of the battery rated capacity). Connections to the power supply source must
be implemented by connecting corresponding poles (+ to + and - to - ).
Pump electrics check
Connect the tester positive probe to pin 4 of the
connector of the fuel pump control device, and the
negative probe to pin 3, making sure there is bat-
tery voltage as indicated in the table.
Specification
Key set to «KEY ON»
Engine revs from 0 to 200 rpm
Engine revs from 200 to 1200 rpm
Engine revs from 1200 to 2000 rpm
Engine rpm ] 2000 rpm

PUMP SUPPLY

Supply to the pump for 13 seconds
Electrical system
Desc./Quantity
Always «OFF»
Always «ON»
0.2 seconds «ON»
9 seconds «OFF»
Always «ON»
ELE SYS - 79