Advertisement
Attaching the Network and Serial Cables
Attaching the
Network and Serial
Cables
Caution
6
3. Use one of the following methods to ground the DeviceMaster 500.
•
Through the power supply by connecting the ground wire on the power
cable using plastic or metal stand-offs.
•
Through the chassis, using metal stand-offs. If plastic stand-offs are used
to mount the board, then you must ground the DeviceMaster 500 using the
power cable.
Note: The maximum diameter of the metal stand-offs should be 0.175" with a
4-40 machine screw. Metal stand-offs are not provided with the
DeviceMaster 500.
4. Optionally, attach the light pipes. The following light pipes have been tested
and found to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.
(P/N:LTP003-0CW-001).
After mounting the DeviceMaster 500, you are ready to connect the cables.
Use the following procedure to attach the serial ribbon and Ethernet cables.
1. If using a ribbon cable, attach the cable built in
Cable
on Page 4 to the header labeled J3.
J3
1
2
9
10
2. Connect a standard Ethernet cable from the RJ45 port on the DeviceMaster
500 to your Ethernet hub or a crossover cable to a server NIC.
The NS-Link device driver's default port setting is RS-232. Make sure
that you do not connect RS-422/485 devices until the appropriate port
interface type has been configured in NS-Link.
Use the next subsection to wire the power terminal connector and verify the
hardware installation.
Installing the DeviceMaster 500 and the SICK LMS Scanner (Windows): 2000472 Rev. C
Building the Serial Ribbon
Ethernet
10/100
Connector
Advertisement
