Removing The Mulching Plug - Makita DLM533 Instruction Manual

1. Align the holes in the lower handle with the holes
in the mower body, and then tighten 4 bolts temporarily.
1
2
► 1 . Lower handle 2. Bolt
2. Firmly tighten 4 bolts which were temporarily
tightened in step 1 using box wrench 13.
3. Align the hole in the lower handle with the hole in
the upper handle, then insert the bolt from inside, and
then tighten the nut from outside with box wrench 13.
Perform the same procedure on the other side.
5
4
3
► 1 . Bolt 2. Lower handle 3. Nut 4. Hole 5. Upper
handle
CAUTION:
that it does not drop off your hand. Otherwise, the
handle may fall and cause an injury.
4. Attach the holders to the handle.
Align the protrusions on the holder with the holes on the
handle so that the protrusions fit in the holes. Position
the cords as shown in the figure.
► 1 . Cord 2. Holder

Removing the mulching plug

1. Open the rear cover.
1
► 1 . Rear cover
2
2. Remove the mulching plug while holding down the
lever.
► 1 . Lever 2. Mulching plug
7 ENGLISH
Hold the upper handle firmly so
1 2
1
1
2