Spare Chassis Replacement Instructions
This document describes how to replace a SnapExpansion XSR
chassis from Overland Storage.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Prepare the Unit
Power Off and Disconnect
If the system is still running, power it down cleanly:
1. Use the Web Management Interface to shut down the
head unit (Maintenance > Reboot and Shutdown >
Shutdown).
This also powers off all the expansion units.
2. When all the LEDs are off, at the expansion unit being
updated, disconnect the power cords.
3. Disconnect the remaining cables from that unit.
Remove the Front Bezel
1. Carefully take hold of the front bezel and pull it straight
out from the appliance until the magnets release.
2. Set the bezel aside on a secure surface.
10400588-001
©2014 Overland Storage, Inc.
SnapExpansion XSR™
Page 1 of 4
Need help?
Do you have a question about the SnapExpansion XSR and is the answer not in the manual?
Questions and answers