Preface - Sun Microsystems StorEdge 6130 Manual

Preface

The Oracle Solaris Cluster 3.3 With Sun StorEdge 6130 Array Manual provides procedures that
are specific to Oracle's Sun StorEdge 6130 array that is placed in an Oracle Solaris Cluster
environment.
Use this manual with any version of Oracle Solaris Cluster 3.3 software. See the
History" on page 6
This book assumes that you are performing one or more of the following tasks:
You want to replace an array component to prevent a failure.
■
You want to replace an array component because you have an existing failure.
■
You want to add (to an established cluster) or install (to a new cluster) a storage array.
■
Note –
of processor architectures: UltraSPARC, SPARC64, and AMD64. In this document, the label
x86 refers to systems that use the AMD64 family of processor architectures.
The information in this document pertains to both platforms unless otherwise specified in a
special chapter, section, note, bulleted item, figure, table, or example.
Who Should Use This Book
This book is for Oracle representatives who are performing the initial installation of an Oracle
Solaris Clusterconfiguration and for system administrators who are responsible for
maintaining the system.
This document is intended for experienced system administrators with extensive knowledge of
Oracle software and hardware. Do not use this document as a planning or presales guide. You
should have already determined your system requirements and purchased the appropriate
equipment and software before reading this document.
for a list of changes to this manual.
This Oracle Solaris Cluster release supports systems that use the SPARC and x86 families
"Revision
5