Operation Mode - A&D UA-1020 Instruction Manual

1. Normal Measurement
Press the
START
in memory. This device can store the last 90 measurements in memory.
2. Recalling the Data
Press the
memory. The average of all measurements is
displayed, as indicated in the figure at the right.
Then, each time the
the memory data is displayed as follows.
Average of all AM (morning) measurements
taken between 4:00 and 9:59.
Average of all PM (evening) measurements
taken between 18:00 and 1:59.
Most recent data (No.n, in the example,
No.35)
Last data (No.1)
For details on recalling the data, refer to
"Recalling the Memory Data".
3. Deleting all Data Stored in Memory
Press both the
and the battery indicator appear. Press and hold
both the and
mark starts blinking to delete all data stored in
memory.
4. Measurement with the Desired Systolic Pressure
Refer to page 14 for measurement with the desired systolic pressure.

Operation Mode

button. Blood pressure is measured and the data is stored
or button to recall the data in
button is pressed,
and buttons. The
buttons until the illuminated
mark
English 7