Running Belt Alignment Adjustment - JMQ A6X Instruction Manual

clockwise. 1/4 laps, note that the left and right must be adjusted
synchronously, so that the running belt can be tightened and the
running belt will not deviate from the center point. If the running belt
is too tight, the left and right synchronization will be adjusted
counterclockwise.
Note
: The running belt cannot be adjusted too tightly. This will
break the running belt, increase the pressure of the front/rear drum,
cause damage to the roller bearing, etc., abnormal noise or other
problems, and only need to adjust to the running belt without
slipping.

Running belt alignment adjustment

When you use the treadmill, the pressure on the two belts is not
the same when running, and the pressure on the running belt is
unbalanced, causing the running belt to deviate from the center. This
deviation is normal and it automatically returns to the center when
no one is running on the running belt. If you don't get back to the
center, you need to run back to the center.Run the treadmill at no
load, adjust the speed to the sixth gear, and observe the distance
from the running belt to the left and right side bars:
● If it is to the left, use a hex wrench to turn the left screw 1/4 turn
18