Download Print this page

Nescafe Milano Combi Operation Manual page 2

Advertisement

WEEKLY Cleaning Procedure
1. Follow "DAILY Cleaning Procedure – Part 1". However, this
time leave internal parts to soak for 20 minutes, using a food
grade sanitiser, for deep clean. Reassemble internal parts on
machine (do not rinse, or close door).
2. Leave coffee machine door open.
3. Remove orange key from lid of machine (o) and insert key
into roof of machine – above canisters (p). This will enable
you to operate the machine in "Door Open Mode".
4. Press "Programme Key" (q) on back of machine door.
(q)
5. Select "Cleaning Mode" by pressing Button 4 (r) on touch
panel on front of machine.
6. Confirm Drip Tray Empty – Press 10 (t)
7. Is Water OK – Press 10 (s)
8. Select "HC", by pressing Button 8 (s) on touch panel
9. When prompted, put a "Brewer Cleaning Tablet" in the
brewer chamber, as shown below and Press Button 10 (t)
1. Skip final coffee? Press any Button for yes (except 1 for
"No").
2. Once completed, remove orange key from door and
replace in lid of machine.
3. Follow "DAILY Cleaning Procedure – Part 2", rinsing
brewer under warm running water, will ensure all traces
off cleaning tablet have been removed.
4. Close and lock door.
5. Perform rinse.
NESCAFÉ Alegria "Combi" Coffee Machine
Summary Operational Guide (Page 2 of 2)
(o)
(p)
(r)
(s)
(t)
MONTHLY Cleaning Procedures
1. Remove the coffee bean hopper, by pushing the orange clip in
to close off neck/supply of beans:
2. Once neck is locked, to remove hopper, lift hopper up and
out.
3. Ideally, you will only have a small amount of beans – empty
these into an air tight container and store in a cool, dry, dark
storage to help them remain as fresh as possible.
4. Using a Food Grade Sanitiser, leave the hopper to soak for 20
minutes.
5. Rinse, then dry completely.
6. Place the hopper back in machine. Tip, put the rear of the
hopper in place, in slot, at rear in the first instance, then
lower down the front of the hopper. Once in place, pull
orange clip back out to "lock" hopper in place.
7. Refill with beans.
Common Faults/Problems:
Description
Action
No Brewer
- Turn machine off and replace the brewer (twist
(Off 8A)
bolt on top of brewer slightly, to help lock
brewer into position).
Switch the machine back on.
Soluble Product:
Check that Powder Chutes are in "Open" position
Only dispensing
hot water
Roast & Ground:
Check that orange clip at the bottom of the
Only dispensing
hopper is in the "open" position.
hot water
No Water (Off 6)
Please ensure that the mains water has not been
turned off, before ringing technical support.
Machine is Off
- Check machine is still plugged in at mains
- Follow the lead to the rear of the machine,
make sure that it has not become unplugged at
the rear of the machine.
- Ensure machine is switched on (button above
electrical lead at the back of the machine).
No Beans
- Fill the Roast and Ground coffee canister with
(Off 9)
Beans
- Ensure that the orange clip/neck of hopper is
"open".
Still not good?
Call Mulmar on 0845 8509818
Important Notes:
1. Always follow best "Food Hygiene Practices" (ie, wash hands
thoroughly before handling products).
2. Summary reference document only. For full details and
procedures, please reference our full "Operators Manual"
UK / Version 3 / July 2019

Advertisement

loading