Unpacking And Checking Carton Contents; Assembly - Vacmaster VOC1218PF Original Instructions Manual

UNPACKING AND CHECKING CARTON
1 Power Head
2 Hose Storage
3 Latch
4 Accessory Storage
5 Caster
6 Container
7 Suction Port
8 On/Off Switch
9 Carry Handle
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head. Secure them with
supplied screws (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for both wet and dry vacuum cleaning with the washable
cartridge filter and pre-filter pre-installed. If the cartridge filter is not installed, refer to page 8.
5) Secure the power head back on the container, using the latches. Insert the locking the end of
the hose into the suction port of the container and lock into place (Fig. 3).
6) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle (Fig.
4).
7) Attach the detachable power cable to the connection lead using the cable restraint hook as
illustrated (Fig. 5).
CONTENTS
10 Blowing Port
11 Power Cord Storage Hook
12 Floor Head Holder
13 Extension Wand (x3)
14 Suction Hose
15 Crevice Tool
Washable Wet/Dry Filter
16
(pre-installed)
17 Nylon Pre-filter (pre-installed) 26 Instruction Manual
18 Artificial Grass Tool

ASSEMBLY

7
19 Hard Floor Tool
20 Detachable Power Cable
21 Cable Restraint Hook
22 Brass Moss Removal Brush
23 Round Brush
Handle With Air Flow
24
Regulation
25 Screw (x6)
27 Filter Retainer (pre-installed)
GB