Maintenance - Vacmaster VOC1218PF Original Instructions Manual

GB
WARNING: ALWAYS TEST THE EFFECT OF THE BRASS BRUSH IN A SMALL AREA.
CHECK THAT THE BRUSH DOES NOT DAMAGE YOUR TYPE OF ARTIFICIAL LAWN
OR YOUR TYPE OF STONE WORK BEFORE CLEANING LARGE AREAS.
1) Fit the brass round brush tool to the end of the extension wands and hose (Fig. 15).
2) Work the moss in a gentle back and forth motion. This will dislodge the roots and the moss is
collected by the vacuum cleaner.
4. Detailed Areas
For the corners around your lawn use the crevice tool.
1) Fit the crevice tool to the end of the extension wands and hose (Fig. 16).
2) Use the crevice tool for any final spot cleaning and to reach the edges and corners of the lawn
and around any plant pots (Fig. 16).
5. Other Outdoor Areas
Use the hard floor tool for any other outdoor flooring, decking or stonework.
1) Fit the hard floor attachment to the floor head holder and attach this to the end of the extension
wands and hose (Fig. 17).
WARNING: REMOVE THE POWERCORD FROM THE POWER SUPPLY BEFORE
CARRYING OUT ANY MAINTENANCE.
1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
2) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the
power head. Do not use cleaning agents or solvents; these may damage the appliance.
3) Check the hose, attachments, and power cord to verify that they have not been damaged or
any debris is trapped and blocking airflow.
1. Cleaning Washable Cartridge Filter & Nylon Pre-filter
1) Remove the filter and clean by gently tapping or brushing dirt off. For optimal performance it is
recommended to replace the old filter with a new filter regularly.
2) Use a mild soap and water solution to wash cartridge filter and nylon pre-filter and rinse with
clean water. Allow the filters to air dry before re-installing (Fig. 18 & 19).

MAINTENANCE

10