Bassra Machine Tools BMT 2000 User Manual page 17

CAREL CONTROLLER
The SEL symbol should be pressed for two seconds. ST1 will start to flash and its
setting will be displayed. Press the up and down symbols until the desired
temperature is reached. Press SEL again and ST2 will be displayed. (Care should be
taken not to adjust ST2 set point as this could stop the machine working if done
incorrectly). Press SEL again to exit setup.
TECHNOLOGIC CONTROLLER
Push key "P" then release it and the display will visualise "SP1". To modify the valve,
press "UP" key to increase it or the "DOWN" key to decrease it. Once the desired
valve has been reached by pushing "P" it is possible to check AL1, (the under
temperature valve set and locked at 165°C). Push "P" once again to exit
programming.
Care should be taken not to adjust any other set points, as this could stop the
machine if done incorrectly.
MAINTENANCE
All maintenance should be carried out by approved B.M.T. engineers.
Keeping the machine clean is often overlooked, particularly with regard to the hose.
The hose should have a piece of carpet, or similar, placed under it where contact is
made with the floor. This prolongs the life of the hose, but only if the carpet is kept
clean and free from pieces of debris, especially glass.
99 Spring Road, Tyseley, Birmingham, United Kingdom, B11 3DJ
BASSRA MACHINE TOOLS LTD.
Tel: 0044 (0) 121 707 4343 / Fax: 0044 (0) 121 707 3535
Website: www. bassra.com / Email: sales@bassra.com