Bmt Manual For Controllers - Bassra Machine Tools BMT 2000 User Manual

13. BMT Manual for Controllers

BMT 1000/2000/3000/4000 MANUAL
Thank you for purchasing machinery from Bassra Machine Tools Limited. The
following are some simple to follow instructions for safe and effective use.
The machine should be full with sealant and special care should be taken to
avoid the sealant level dropping below the top row of heaters.
All temperatures should be set to manufacturers recommended values.
Do not drag the machine by the hose as this can cause severe damage.
The lid should be kept closed to avoid any debris getting into the hopper.
The machine should never be left on without use for any length of time.
When the machine operative is ready to begin sealing the units, the machine
should be run back into the hopper for a few seconds to ensure no cold sealant
is injected into the unit.
Non-compliance will result in the guarantee being void.
Refer to the table below for hours 1
TYPE OF
MACHINE
BMT 1000
BMT 2000
BMT 3000
BMT 4000
TIMER
The timer is 7-day timer with an override option. Each segment of the dial is
equivalent to one hour. To set the timer to switch on/off, simply pull out the
appropriate segments.
For winter/summer time adjustments then simply turn the hands of the clock to the
new correct time. Refer to the table above and check the numbers of hours the timer
should be set prior to use.
CONTROLLERS
During commission of your machine the temperatures will be set for the type of
sealant you intend to use. If however, you need to alter the set temperature, follow
the following procedure: -
99 Spring Road, Tyseley, Birmingham, United Kingdom, B11 3DJ
ST
NO. OF HOURS 1
TIME PRIOR TO USE
3 Hours
4 Hours
5 Hours
6 Hours
SET-UP
BASSRA MACHINE TOOLS LTD.
Tel: 0044 (0) 121 707 4343 / Fax: 0044 (0) 121 707 3535
Website: www. bassra.com / Email: sales@bassra.com
st
time prior to use etc.
NO. OF HOURS
PRIOR TO USE
2 Hours
3 Hours
3 and a half Hours
4 Hours
TIMER
Not Fitted
Fitted
Fitted
Fitted