Safety Rules For Filling The Hotmelt Material - Bassra Machine Tools BMT 2000 User Manual

6. Safety Rules for Filling the Hotmelt Material

The following rules must be taken into attention while filling the Hotmelt material.
• The level of the Hotmelt material should be checked every time before starting
the machine. If the machine is working non-stop, the operator should check
the level of the material. It should never drop below the tank tubes.
• Hotmelt material is taken out of its package in a solid state, and must be put
inside the tank without touching any external material.
• The material in its solid state must be put slowly into the tank. Material must
not be thrown from a higher place otherwise this can damage the tubes.
• Eyeglasses and masks must be used while the tank is open. Direct contact of
hot air rising from the tank should be avoided.
• High temperature warning signs must be taken into consideration while
working in the tank cap and its surroundings.
• Use the machine in a well ventilated area.
• Gloves must be worn while gunning to prevent burns.
• The material's chemical composition, which is defined in the closure, has no
toxic property. Any kind of toxic material should not be used. BMT strongly
refuses liability in case of any hazards that could arise from misuse of the
machine and material.
• The machine should be positioned on a level surface.
• Ensure that in between operations, the gun is placed in a safe place to ensure
that nobody touches the hot parts.
99 Spring Road, Tyseley, Birmingham, United Kingdom, B11 3DJ
BASSRA MACHINE TOOLS LTD.
Tel: 0044 (0) 121 707 4343 / Fax: 0044 (0) 121 707 3535
Website: www. bassra.com / Email: sales@bassra.com