Summary of Contents for National Instruments ELVIS RIO CM
Page 1
Operate the NI ELVIS RIO CM only as described in the user documentation. Caution Do not operate the NI ELVIS RIO CM in a manner not specified in this document. Product misuse can result in a hazard. You can compromise the safety protection built into the product if the product is damaged in any way.
Clean the NI ELVIS RIO CM with a soft, nonmetallic brush. Make sure that the device is completely dry and free from contaminants before returning it to service. Ensure that the environment in which you are using the NI ELVIS RIO CM meets the following specifications. Operating temperature 10 °C to 35 °C...
Store the device in the antistatic package when the device is not in use. Verifying the Kit Contents Verify that the following items are included in the NI ELVIS RIO CM kit. Figure 1. NI ELVIS RIO CM Kit Contents 1.
Page 4
Position the NI ELVIS RIO CM on the NI ELVIS II Series Workstation. Slide the Workstation Interface Connector of the NI ELVIS RIO CM into the Prototyping Board Connector on the workstation and ease it into place.
Page 5
Installing the NI ELVIS RIO CM section for more information. Connect the USB Device Port on the NI ELVIS RIO CM to the computer with the USB cable. Turn on the Workstation Power Switch to power up the NI ELVIS II Series Workstation.
Page 6
Turn on the Prototyping Board Power Switch to power up the NI ELVIS RIO CM. Launch the Getting Started Wizard from the USB Monitor. Note The Getting Started Wizard can also be launched through the LabVIEW Getting Started Window or LabVIEW Project right-click menu.
United States, visit the Worldwide Offices section of ni.com/ niglobal to access the branch office websites, which provide up-to-date contact information, support phone numbers, email addresses, and current events. 8 | ni.com | NI ELVIS RIO CM Getting Started Guide...