Advertisement
Load ihe batteries as follows:
O
Remove the battery compartment lid.
@ etace the batteries in the battery compartment as
indicated inside the battery compartment.
€) Replace the lid.
Note:
.The infra-red beam should be tansmitted directly at the
lnfra-red Remote Control Receiver on the front of the
VTR.
.Direct sunlight may interfere with the beam.
.The lightsensing angle of the Infra-red Remote Conirol
Receiver in the VTR is about 30" tor each side from the
centre.
.The unit should be used within a ranqe of about 7 meters
from the front of the VTR.
How to Operate the Digital Scanner
Set the Digital Scanner On/Off Switch to "ON".
.lf no operation is performed for more than 25 seconds (4
minutes during setting of the clock time), the scanner will
automatically switch over to the power-saving standby
condition and the lamp will go off. (ln this case, if bar
codes have already been read but not yet transmitted to
the VTR, the data will be cancelled.)
.When the Digital Scanner On/Otf Switch is set to "ON" but
the lamp is not lit, set the switch to "OFF" and then to
"ON" again.
Note:
The bar codes "VTR 1" and "VTR 2" in the column
"REMOTE MODE" on the Programming Sheet cannot be
used with this unit.
.lf the bar code "VTR 2" is traced by mistake, transmission
to the VTR becomes impossible. To remedy this condi-
tion. trace the "VTR 1" bar code. (The indication "VTR 2"
in the Bar Code Reader Display will disappear.)
Place the Digital Scanner vertically on the Small Box.
Trace the bar code quickly in the direction of the arrow.
.Treat the Programming Sheet with care. lf the sheet
geis dirly or scratched, the bar code reading may
become impossible.
.Protect the Digital Scanner lrom strong shocks and
vibration. Keep it away from water and places with
high temperature and humidity.
.lf the bar code is traced slowly, it cannot be read
correctly.
.When there is no "Beep" sound, the reading of the
bar code is incomplete. Trace the bar code agatn.
.When using the Programming sheet, put it on tlat
sudace: Reading the bar codes while holding it in
your hand or bending it, may result in incorrect
operation.
.Do not deviate from the bar code, nor stop tractng
haltway.
.Do not stant the scanner to trace the bar code.
Recommendalion
To save battery power, make sure to set the Digital Scanner
On/Otf Switch to "OFF" after using the Digital Scanner.
When the batteries are exhausted, the bar code reading
can no longer be performed.
Although the lamp in ihe tip of the Bar Code Reading
Section lights up:
.No figures appear in the Bar Code Reader Display
.No beep sounds is heard;
The tip of the Bar Code Reading Section is probably
clogged with dirt.
Cleaning
O
Turn the Cap of Bar Code Reading Section 45" coun-
terclockwise, as shown below.
.Remove dirt and dust from the hole
ol the Cap.
(A)
(B)
n"j"/v"*
H
@ Gently wipe the tip ol the lamp with a soft cloth.
ns-
LamP
A9
(ffi)
.Reattach the Cap and loct< it by
Ff-l
turning il clockwise.
Trace the bar code
Bar Code/
completely past the lasl bar.
sound indicates
that the bar code
was read
completely.
(8)
Advertisement
