Advertisement
MEIVlORY/REf
SEARCH
n
RESET/IN
E
cLocK/
COUNTER
E
MONITOR
Repeatedly pressjng this button will change the indication in
the following order: "M" (Memory)-"R" (Repeat)r"S"
(Search)- "RS" (INDEX Repeat)-all indications are
o l f + " M " . . .
By pressing this button when the VTF On/Off Switch is set
to "On", it is possible to change over the display mode of
the Clock/Counter Display in the Multi-Function Display
from "Clock" to "Countei' Display and vice versa.
.Even if the selector button is set for "Counter" the disolav
will aulomatically changes over lo Clock" Display in ail
the following cases; When you set the VTR On/Off Switch
to "Off", adjust the clock to present timej programme a
timer recording, check a timer recording programme or
programme and perform an OTR.
.When the Clock/Counter Display shows the time, the
counter cannot be reset and the Memory and Search
Function cannot be activated ("M", "R", "S" and,,RS',
indication does not light up).
,//
\)
{ lAEPEAI/
/ I N D E X
-
\
E
E t g
: :
6--Ec
o o
--l!lc
a n
E O E
E f f
The Memory function makes it simple and fast to find a
certain position on the tape later again, simply by pressing
the Reset Button at that position to set the tape counter to
"0:00.00" and by pressing the l\4emory/Repeavsearch
Button. During Rewind or Fast Forward, the tape will then
stop at approximately the desired position.
.Even if the Clock/Counter Display is switched over to
"Clock" Display after pressing the Memory/Repeav
Search Button, the l\y'emory lunction will stop the tape
at the desired position.
When the lvlonitor Button is kept pressed during playback
(except Cue or Review), the broadcast picture of the
selected programme position (channel) or input signal
through Audio/Video input socket will be displayed. When
this button is released, the picture will change back to the
playback picture of the tape.
lf vertical jitter occurs during Still playback, adjusl the
V-Lock Control (on the rear of the VTR) for the correspond-
ing recording speed (LP or SP) with the screw driver. A
one-time adjustment should be allthat is necessary.
V-LOCK
M
lMemory Indicator
COU[T
Advertisement
