Advertisement
SYMPTOM
CAUSE
FEMEDY
Playback picture is not in
colour.
Playback picture has
large amounts of "snow"
Reception channelwas not adjusted
correctly during recording.
Readjust reception channel correctly.
TV set is not properly tuned to the video
olavback channel of the VTR.
Properly tune the TV set to the video playback
channelof the VTR.
The video heads are clogged with dirt
Consult qualif ied service personnel.
The video heads are abraded.
Consult qualif ied service personnel.
Taoe is old and/or defective.
Use newtape.
Remote Controller (Digital
Scanner) does not work.
Bemote Controller (Digital Scanneo is not
being pointed at Infra-red ReceiverWindow
on the VTR.
Point the Remote Controller (Digital ScanneO
at lnfra-red Receiver Window on the VTR.
Distance is too far,
Use the Remote Controller (Digital Scanner)
within 7 m from the VTR.
An obstacle is between Remote Controller
Remove obstacle.
(Digital Scanner) and VTR.
Batteries are exhausted.
Replace batteries.
Battery polarities (+, -) are reversed.
lnsert batteries correctlv.
Bar code reading with Digital
Scanner is impossible.
The Digital Scanner is in the power-saving
standby condition.
Set the Digital Scanner On/Otf Switch to
"OFF" and then to "ON" again.
The bar code has been iraced too slowlv.
Trace the bar code quickly.
The bar code was not traced allthe wav
from the Small Box Dastthe last bar.
Trace the bar code correctly.
The bar code was not traced straight.
Trace the bar code straight from lefl to right.
Bar Code Reading Section is clogged
with dirt.
Bar Code Reading Section requires cleaning.
(See page 8.)
The VTR is turned off.
Turn the VTR on.
Transmission from the Digital
Scanner to the VTR cannot be
performed.
The VTR is in an oDeration mode.
Put the VTR into the stoo mode.
There is no unoccupied timer programme
number left.
A maximum ol8 timer recordings can be
programmed at the same time.
Reading a bar code was not followed by a
"beep" sound from the Digital Scanner
Perform the bar code reading again.
The transmission was nol followed by a
repeated "beep'sound from the VTR.
Keep pressing the Transmit Button until the
confirmation sound is heard.
Advertisement
