Advertisement
Before requesting service, check the following points once
again.
SYMPTOM
CAUSE
REMEDY
Power doesn't turn on.
Mains lead is not connected.
Connect mains lead to mains outlet.
The Timer Record Function is set to "On"
Set the Timer Hecord Function to "Off".
Power is on but unit doesn't
operate.
Dew condensation inside the VTR.
Wait untilthe Dew Indicator " |l " goes off.
Safety devices are operating.
Turn off the VTR On/Off Switch, disconnect
mains cord from outlet, then reconnect mains
cord to mains outlet and turn on the VTR
On/Off Switch again.
TV programmes cannot be
recoroeo.
Cor.nection of aerial lead is not correct.
Connect aerial lead correctly.
Reception channel is not properly tuned.
Tune reception channel.
The Input Signal Selector is not set correctly. Set the Input Signal Selector to ,,Tuner,,.
OTR Function (One-Touch
Timer Recording) cannot be
performed.
Clock is flashing "0:00".
Set clock to present time.
Unattended timer recording
cannot be performed.
Recording start or recording stop time
setting is incorrect.
Set recording start and recording stop time
correctly.
The Timer Record Function is set to "Off".
Sel the Timer Record Funclion to 'On
Clock shows incorrect time.
Adjust clock to present time.
Clock is flashing at "0:00"
Set clock time and perlorm timer setting.
The Input Signal Selector is not set to
"Tuner".
Set the Input Signal Selector to "Tuner".
Recording via external input
The Input Signal Selector is not set correctly. Set the Input Signal Selector to "Line/Audio"
terminals cannot be performed.
Recorded programmes wjth
two-channel sound (stereo,
bilingual or Simulcast) can not
be played back.
Setting of the Audio Output l\4ode Selector
Button (Remote Controller) is not correct.
Press the Audio Output l\.4ode Selector Button
(Remote Controller)
to select the desired
audio playback mode. (See page 25.)
Advertisement
