Playing Compact Discs; Normal Playback - Emerson SmartSet CKD9917BK Owner's Manual

Playing Compact Discs

NOTE: This CD player can read CD-R/RW discs, in addition to normal CDs,
however; the compatibility of CD-R/RW discs may be affected by the type of
software that was used to cr eate the discs, as well as the quality and condition
of the blank media you are using. 100% compatibility cannot be guaranteed.
This is not an indication of a problem with the player.

Normal Playback

1.) Press the ALARM OFF/POWER button to switch the unit 'On'. The
POWER indicator will light.
2.) Press the
3.) Press on the CD door in the area marked
OPEN to open the door. If you have not
already done so, remove the 'dummy CD'
transit protection card from the CD player and
discard it.
4.) Place your disc on the center spindle with the printed label side facing up.
Press down near the center of the disc to make sure it is firmly 'seated' on
the spindle, press OPEN area to close the CD door.
5.) The " – –" of "cd – –" flashes while the player
reads the disc. The display will show the total
number of tracks for a few seconds and then
return to the correct time. To see the track number
at any time during playback press the ALARM
SET/DISPLAY button. The track number will
appear for several seconds and then the
display returns to the correct time.
NOTE: If the disc is inserted incorrectly, or if
the disc is badly scratched and cannot be
read by the player, "d ISC" will appear on the
display for a few seconds, and then the
display returns to the correct time.
6.) Press the
display will briefly show "cd: 01" (Track 1)
and playback on track 1 begins. After a few
seconds the display returns to the correct
time.
button to enter CD playing mode
button to begin playback. The
12
MON
CD
MON
CD
MON
CD
MON
CD CD PLAY PLAY
MON MON