Method For Checking Door Lock Striker; Method For Checking Window Washer Fluid Level, Adding Fluid - Komatsu D61EX-24 Operation & Maintenance Manual

MAINTENANCE

METHOD FOR CHECKING DOOR LOCK STRIKER

Measure wear (A) of the door lock striker.
If wear (A) is 0.5 mm {0.02 in} or more, replace the door lock
striker.
If you use it as it is, its play increases and can cause breakage
of the hinge and lock door.

METHOD FOR CHECKING WINDOW WASHER FLUID LEVEL, ADDING FLUID

Perform this check when no window washer fluid comes out.
1.
Open the hydraulic tank inspection cover.
2.
Check the fluid level in window washer tank (1).
If the fluid level is low, remove cap (2) and add window
washer fluid for automobile through the filler port.
Be careful not to let dirt or dust get in when adding fluid.
(Mixture ratio of pure washer fluid and water)
The proper mixing proportion varies with the ambient temperature. Add washer fluid diluted with water at the
following proportion.
Area, season
Normal
Winter in cold district
Winter in extremely cold district Pure washer fluid
There are 2 types depending on the freezing temperature: -10 °C {14 °F} (general use) and -30 °C {-22 °F}
(cold district use), select according to the area and season.
Mixing proportion
Washer fluid 1/3: water 2/3 -10 °C {14 °F}
Washer fluid 1/2: water 1/2 -20 °C {-4 °F}
MAINTENANCE PROCEDURE
Freezing temperature
-30 °C {-22 °F}
4-35