Related Commands - H3C S5150-EI Series Troubleshooting Manual

Execute the display acl command to check whether the ACL is configured correctly.
If the ACL is configured incorrectly, reconfigure it.
If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact H3C Support.
ACL used in a packet filter
To resolve the problem when the ACL is used in a packet filter:
1. Verify that the packet filter is configured correctly.
Execute the display packet-filter command to check whether the packet filter is configured
correctly.
If there are any configuration errors, reconfigure the packet filter.
If there is no configuration error, go to step 2.
2. Verify that the ACL is configured correctly.
Execute the display acl command to check whether the ACL is configured correctly.
If the ACL is configured incorrectly, reconfigure it.
If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact H3C Support.

Related commands

This section lists the commands that you might use for troubleshooting ACLs.
Command
display packet-filter
display qos-acl resource
display qos policy control-plane
display qos policy global
display qos policy interface
display qos vlan-policy
display traffic classifier user-defined
display traffic behavior user-defined
Description
Displays whether an ACL has been successfully applied to
an interface for packet filtering.
Displays QoS and ACL resource usage.
Displays information about the QoS policies applied to the
specified control plane.
Displays information about global QoS policies.
Displays information about the QoS policies applied to an
interface or to all interfaces.
Displays information about QoS policies applied to VLANs.
Displays traffic class configuration.
Displays traffic behavior configuration.
11