oticon Opn Series Instructions For Use Manual page 36

Note: This equipment has been
tested and found to comply with
the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to
correct the interference by one or more
of the following measures:
70 About Start-up Handling Options Tinnitus Warnings
– Reorient or relocate the
receiving antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into
an outlet on a circuit different
from that to which the receiver
is connected.
– Consult the manufacturer or an
experienced radio/TV technician
for help.
More info
The manufacturer declares that this
hearing aid is in compliance with the
essential requirements and other
relevant provisions of Directive
2014/53/EU.
Waste from electronic
equipment must be
handled according to
local regulations.
Declaration of Conformity is
available from the manufacturer.
Denmark
71