Audio Induction Loops - Siemens signia Carat primax User Manual

Automatic program switch
(AutoPhone or TwinPhone)
Your hearing instrument can automatically select
the telephone program when you bring the telephone
handset close to the hearing instrument. TwinPhone even
transmits the call into both ears. When you are finished
speaking on the phone, move the handset away from the
hearing instrument and microphone mode will re-engage.
If you want to use this function, ask your Hearing Care
Professional to do the following:
●
Activate the AutoPhone or the TwinPhone function.
●
Check the telephone receiver's magnetic field.
For the automatic program switch, your hearing
instrument detects the telephone receiver's magnetic
field. Not all telephones produce a magnetic field
strong enough to activate this function. In this case,
you can use the AutoPhone magnet, which is available
as an accessory, and attach it to the telephone
receiver.
See the AutoPhone magnet user guide for instructions on
how to position the magnet.
NOTICE
Use the approved AutoPhone magnet only. Ask
your Hearing Care Professional for this accessory.
24
Audio induction loops
Some telephones and public places like theatres offer the
audio signal (music and speech) via an audio induction
loop. With this system, your hearing instruments can
directly receive the desired signal – without distracting
noise in the environment.
You can usually recognize audio induction
loop systems by certain signs.
Ask your Hearing Care Professional to configure a
telecoil program.
Switch to the telecoil program whenever you are in a
X
place with an audio induction loop.
If a telecoil program is configured for your hearing
instruments, it is listed in section "Settings".
Telecoil program and remote control
NOTICE
For instruments with wireless connectivity:
When the telecoil program is active, the remote
control may cause a pulsing noise.
Use the remote control with a distance greater
X
than 10 cm (4 inches).
25