2N StarGate How To Set
Hide thumbs Also See for StarGate:

Advertisement

®
2N
How to set IP addresses
Version
Firmware
StarGate / 2N
3.7
2.30.05
®
BlueTower
www.2n.cz

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the StarGate and is the answer not in the manual?

Questions and answers

Summary of Contents for 2N StarGate

  • Page 1 ® ® StarGate / 2N BlueTower How to set IP addresses Version Firmware 2.30.05 www.2n.cz...
  • Page 2 For product 2N StarGate you need 3 IP addresses. 1x- basic CPU, 1x – enhanced CPU (eCPU), 1x VoIP card. Settings of IP´s As first step it is recommended to set up IP address of basic CPU. You need to connect your notebook via serial cable RS-232 to the CPU board.
  • Page 3 default gateway. Then go to the”VoIP parameters” where you can set IP address of VoIP card, it’s called “VoIP card/MGCP gateway“. The last step now is to set IP address on eCPU. To do that you have to switch off your gateway and plug out CPU board from the case (unscrew both screws).
  • Page 4 done, connect your notebook to the same network like gateway is in and open command window. Try to ping all your set IP addresses for assurance, that all your IP´s are set properly. IP behind NAT Solution If you want to use your gateway behind NAT, there are two ways how to arrange your IP addresses.
  • Page 5 2N TELEKOMUNIKACE a.s. Modřanská 621, 143 01 Prague 4, Czech Republic Tel.: +420 261 301 500, Fax: +420 261 301 599 E-mail: sales@2n.cz Web: www.2n.cz PR 1121 v3.7...

This manual is also suitable for:

Bluetower

Table of Contents