Load The System Defaults; During Post, Press F2 To Access The Uefi Set-Up Utility - Allen-Bradley H Series User Manual

Load the System Defaults

Follow these steps to save diagnostic reports.
TIP
1. Select Generate Report in the Options menu and press Enter.
2. Select Report destination and press Enter.
3. Select File and press Enter.
4. Select the device path to generate the log report and press Enter.
If you must generate the report in the current file system, press Enter.
Otherwise, select Continue and press Enter.
5. Enter log file details (file name and heading) for the report.
The default file name is AMIDiag.LOG.
6. Set the report parameters, such as log errors, log test activities, log test start
time, log test end time, log errors only, log errors only with time, Append
to old log file, Log device info on fail, Log device info on abort.
7. To exit the submenu, Select Continue and press Enter.
You do not need to disconnect or move your computer to perform an initial
diagnosis. The selected test affects the process, which can take as little as 5
minutes or as long as 8 hours. After Diagnostics has run, you can generate a
report for analysis by a technical support representative, which expedites any
necessary repair process.
If the computer fails after changes in the set-up menus, load the system default
settings to correct the error. These default settings have been selected to optimize
computer performance.
Follow these steps to load the system defaults.
1. Restart the computer as specified in

2. During POST, press F2 to access the UEFI set-up utility.

TIP
3. Depending on your computer series, press or select the system defaults and
exit the UEFI set-up utility.
Rockwell Automation Publication 6181X-UM002B-EN-P - November 2019
Use the arrow keys on a keyboard to navigate between UEFI menus
and menu selections.
Restart the Computer on page
Use the arrow keys on a keyboard to navigate between UEFI menus
and menu selections.
Troubleshoot the System Chapter 6
31.
71