Brinly PA-40 BH Owner's Manual page 20

================================================================================================
STEP 7
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
FLIP THE AERATOR OVER:
A. Push the Axle Assembly (10) through the left side plate as far as possible
and rotate so the hole in the flat plate faces to the rear as shown.
Find this hardware:
- x24 Hex Head Bolt (19) - 5/16" x 1.5"
- x24 Lock Nuts (32) - 5/16"
Install the Lift Handle Assembly (11) with the welded tube facing out, to the Axle
Assembly (10). Secure with Hex Bolt (19) and Nylon Lock Nut (32).
B. Slip Handle Grip (14) over end of Lift Handle Assembly (11).
NOTE: Soapy water will help while adding the handle grip (14).
ASSEMBLY: 48" Plug Aerator ( PA-48 BH )
NOTE: Make sure the
Axle Assembly Flat Plate (10)
and Lift Handle Assembly (11)
are pointing towards the rear
as shown.
20 L-1762-G