Advertisement
User manual
IMPORTANT!
Being careful not to damage the bearing spindle on top of the pendulum shaft, assemble the
pendulum, starting by sliding a solid metal disc over the pendulum shaft so that it rests on the
wooden blocks. Be sure to place a felt mat between each metal disc, building the pendulum with
three solid discs at the bottom, then six half-cut-away discs, then two more solid discs, finally adding
the solid disc engraved with the words Clearaudio
Disc engraved with
Statement
„Clearaudio
Disc, solid
(2 pcs.)
Disc, half cut away
(6 pcs.)
Disc, solid
(3 pcs.)
Please note:
Statement V2 TT1
If you are using the
cut-away section at the rear of the turntable.
3.
Place the four cork damping plates on top of the four
corner pillars.
Please note:
Again,
being careful
top of the pendulum shaft, lower the stainless steel cross
frame over the pendulum shaft so that is rests on the four
cork damping plates.
8
"
Pic. 4: Placing the discs
tangential tonearm, position the half-cut-away discs with the
Place 4 pcs. damping
plates if not assembled
already from the factory
not to damage the bearing spindle on
Statement V2.
Pic. 5: Placing the cork damping plates
© clearaudio electronic GmbH, 2018/05
Place a felt mat in
between each stainless
steel platters
Advertisement
