Storage; Maintenance Table - Maaselan Kone Oy Hakki Pilke 37 Series Instructions For Assembly, Operation And Maintenance

be cleaned from the machine with pressurised air, for example. The machine can also be washed with a
pressure washer, as long as the water jet is not aimed directly at the bearings or electrical equipment.
Always ensure that the machine and the working area are sufficiently clean when operating the splitter.
The machine must always be cleaned after use. Wash the machine as necessary but always in conjunction
with prolonged storage. After washing, the splitter must be lubricated according to the instructions in
Section 8.0.

10.0 Storage

Although the splitter is intended for outdoor use, it should be stored covered in a sheltered location or
indoors. Before prolonged storage, the machine must first be cleaned, then washed according to Section
9.0 and lubricated according to Section 8.0.

11.0 Maintenance table

Target Task
Angle transmission Check
oil 1st change
2nd change
Hydraulic oil Check
Normal conditions 1st change
2nd change
Oil filter Always
when
changing oil
Valve mechanism Lubrication
All levers Lubrication
V-belts Check and
Angle transmission replace
necessary
Cutting blade Sharpen as
necessary
Machine Clean
Wash
Electric motor Clean
Electrical Clean
equipment
Daily Interval
100 h
X
X
X
X
X
as
X
In conjunction with storage
X
X
Original
53
Interval Interva
500 h l 1,000
h
X
X
X
Substance/accessory
item
SAE 80
Amount 42 l
E.g. Teboil S 32
Neste Hydrauli 32
CR-50
Lubrication oil, spray
Lubrication oil
A-38, A36, A98, XPA850
2021
Chain:66 loops, pitch
0.325"
Flange: 16", 1.6 mm
groove
Version 1-2011