The Control; The Wheels; The Front Wheels - Faaborg Rehab Technic Click & Go Series User Manual

5.2

The control

The control of the Click & Go Professional II the operation of Click & Go Professional II is going
through a control box (photo 3) and a throttle (photo 4). The control panel on the Click & Go
Professional II is standard placed on the push handle of the push propulsion. You can use the
control panel on both the left and the right side of the wheelchair, depending on your own
preference.
Photo 3
With the red button on the left of the control box, you can turn the push propulsion on and
off. With the black button on the right on the control box, you can set the support of the push
propulsion in forward (F) and in reverse (R) motion. If the push propulsion is turned on the
LED lights below the word 'Status' turn green. At the top of the control panel is shown how
full the battery of the push propulsion is. Finally, you can at the bottom of the control panel,
adjust the speed of the push propulsion.
5.3

The wheels

On the push propulsion are driving wheels and front wheels attached. These should be
checked regularly for wear. By checking the wheels for wear, prevents the push propulsion
provides less support to propel the person in the wheelchair.

5.3.1 The front wheels

The front wheels (photo 5) of the push propulsion have the function to confirm the push
propulsion properly to the wheelchair. By driving the push propulsion in the right place for
the attachment point on the wheelchair, you can easily fix the push propulsion to the frame
of the wheelchair.
Smedemestervej 9 |5600 Faaborg | Denmark | T: +45 710205553 | E: office@faaborg-rehab.dk| W: www.faaborg-rehab.dk
Photo 4
Photo 5
© 2015 Click&Go, Faaborg Rehab Technic ApS
8/15