Table of Contents
Advertisement
6.1.2 PU tires
More and more we use PU tires (polyurethane or puncture-free tires) on the push propulsion.
You can recognize these tires because they do not have a valve. These tires have the
advantage that they do not need to be pumped up and cannot be punctured. This PU tire can
just as an air tire wear out. Check periodically to see if the tread is still deep enough.
6.2
Cleaning of the push propulsion
Cleaning your push propulsion is important and should be done regularly. You can get your
push propulsion best cleaned as described below.
Clean the upholstery, chassis and plastic components on the push propulsion regularly
•
with a mild soap and water. Never use abrasive cleaners, they can damage the varnish.
Also, never use steam or high pressure cleaners;
Wax the varnish of the chassis regularly. Never use solvents, abrasive waxes, caustic
•
chemicals or spray silicone;
Dry the push propulsion after cleaning. Also dry you push propulsion after you have used
•
it, for example, during rain.
6.3
Batteries
For maximum performance and maximum battery life of the push propulsion, you need to
charge your batteries after using. On that way, the batteries are recharged regularly, this is
better for the batteries. When charging, it is also advisable to fully charge the batteries for a
new use of the push propulsion.
6.4
Service checklist
To maximize the lifetime of your push propulsion, we recommend you to get your push
propulsion checked, at least once a year, by an authorized Faaborg Rehab dealer. The form
below can be used for this check. The intensity of use of the push propulsion can vary greatly
from person to person. Therefore, it may be that your push propulsion needs a check several
times a year. Furthermore, maintenance is not covered under warranty.
Smedemestervej 9 |5600 Faaborg | Denmark | T: +45 710205553 | E: office@faaborg-rehab.dk| W: www.faaborg-rehab.dk
© 2015 Click&Go, Faaborg Rehab Technic ApS
12/15
Advertisement
Table of Contents
