Table of Contents
Advertisement
Available languages
Available languages
KR_ESPRESSO_PERFECTO_XP4200_NC00027827-01 06/12/11 16:20 Page15
11. TROUBLESHOOTING
Problems
The filter holder is blocked.
The coffee is not dry after
the
water
has
through.
The espresso flows too
slowly.
Water flows from the filter
holder after the espresso
has been made.
Ground coffee in the cup.
The espresso is not not
frothy/has no crema.
The water tank leaks when it
is moved.
Water leaking underneath
the appliance.
Cracking noises are heard
from the filter holder.
The pump is abnormally
noisy.
Possible causes
You have forgotten to release the
filter holder.
You have not tightened the filter
passed
holder correctly.
The coffee is too finely ground, too
oily or powdery.
The filter holder is dirty.
The water grill is dirty.
The selection knob has not been
placed in the position "Resistor".
Premature formation of scale due to
very hard water.
The filter holder is dirty.
The coffee is too finely ground.
The coffee is too old or has become
stale.
The coffee is not suited to making
espresso.
There is not enough coffee in the
filter holder.
The valve at the bottom of the tank is
dirty or faulty.
The valve is blocked by scale
Inside leak.
This is normal: safety lock on the
filter holder.
No water in the tank.
Solutions
Press the
button while turning the
filter holder towards the left
Tighten the filter holder more.
Choose a more coarsely ground coffee.
Clean your filter holder according to the
instructions in paragraph 8.B.
When the appliance has cooled down,
clean the water grill with a damp sponge.
Turn the d1 control switch to
Descale the espresso machine according
to the instructions (paragraph 9).
Clean the filter holder with hot water.
Press the
button to eliminate any
remaining coffee. Shake it to remove of
any water (also refer to paragraph 8.B.)
Use a more coarsely ground coffee.
Use a more recently ground fresher
coffee.
Use a finer espresso ground coffee, and
only use Espresso ground coffee
Add more coffee.
Wash the water tank and activate the
valve at the bottom of the tank with your
finger.
Descale the appliance as described in
paragraph 9.
Check that the tank is fitted correctly. If
the problem continues, do not use the
appliance, contact an approved service
centre.
Switch off the appliance (position
the water tank and switch back on.
English
(fig. 14)
.
(fig. 6)
.
), fill
15
Advertisement
Table of Contents
