MEDIATEK MT7612 Manual page 13

Offset Field
0
1
36h
2
3
4
5
6
7
37h 0
MediaTek Confidential
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.
Hardware Radio Control.
0: disable hardware radio control (default value).
1: enable hardware radio control.
When "hardware radio control" bit is enabled (=1), the driver will read MAC's GPIO
status. When GPIO pin is low, the radio is disabled. When GPIO pin is high, the
radio is enabled.
The Radio ON/OFF is controlled by both software UI and MAC's GPIO pin.
TX power temperature compensation scheme enable (TC enable)
0 : disable temperature compensation
1 : Enable temperature compensation
This bit will disable/enable temperature compensation scheme.
While this bit is enable, it means Tx power TSSI scheme is disable(0x37 bit5 = 0)
and using TC scheme.
User must fill 0x53~0x54 and 0xF2~0xF5 for TC usage.
External 2.4GHz band LNA.
0: Board without external LNA for 2.4GHz band must set this bit to 0.
1: Board with external LNA for 2.4GHz band must set this bit to 1 (default value).
External 5GHz band LNA.
0: Board without external LNA for 5GHz band must set this bit to 0.
1: Board with external LNA for 5GHz band must set this bit to 1.
Proprietary TEST BIT.
For debug purpose. Default value is 0.
2.4GHz side band for 40MHz BW.
For debug purpose.
5G side band for 40M BW
For debug purpose.
WPS Push Button Configuration control.
0: disable WPS PBC control (default value).
1: enable WPS PBC control.
The WPS PBC function is controlled through GPIO[11].
If LED mode set to "Signal strength"(64), WPS PBC will be disabled.
40M BW in 2.4GHz band.
0: enable 40MHz bandwidth for 2.4GHz band
1: disable 40MHz bandwidth for 2.4GHz band
© 2013 MediaTek Inc.
This document contains information that is proprietary to MediaTek Inc.
EEPROM Content
Confidential B
Description
MT7612
Page 13 of 32